Gun Digest

Top 10 Tools for Centerfire Rifle Disassembly

Tools and tips for rifle disassembly

In his introduction to the new Gun Digest Book of Centerfire Rifles Assembly/Disassembly, gunsmith Kevin Muramatsu outlines his general tips for preparing to take apart a rifle. They are:

You'll also want good tools. Here are Muramatsu's top 10 recommendations for general centerfire rifle disassembly.

1. Instrument Screwdrivers

The tiniest of these fine German instrument screwdrivers from Brownells is too small for most gun work, but you’ll see the rest of them used frequently throughout the book. There are many tight places where these will come in handy.

2. Standard Screwdrivers

When a larger screwdriver is needed, this set from Brownells covers a wide range of blade sizes and also has Phillips- and Allen-type inserts. The tips are held in place by a strong magnet, yet are easily changed. These tips are very hard. With enough force you might manage to break one, but they’ll never bend.

3. Bent Sharpnosed Pliers

You should have at least one good pair of bent sharpnosed pliers. These, from Brownells, have a box joint and smooth inner faces to help prevent marring.

4. Parallel Jaw Pliers

For heavier gripping, these Bernard parallel-jaw pliers from Brownells have smooth-faced jaw-pieces of unhardened steel to prevent marring of parts.

5. Gunsmiths' Hammer

For situations where a non-marring rap is needed, this hammer from Brownells is ideal. It is shown with nylon faces on the head, but other faces of plastic and brass are also available. All are easily replaceable.

6. Metal Gunsmithing Hammers

For drifting out pins, these small all-metal hammers from B-Square are the best I’ve seen. Two sizes (weights) are available and they’re well worth the modest cost.

7. Sharpnosed Forceps

For situations where reach and accessibility are beyond the capabilities of sharpnosed pliers, a pair of large sharp-nosed forceps (tweezers) will be invaluable.

8. Nylon Drift Punch

One of the most-used tools is this nylon tipped drift punch, shown with an optional brass tip in place on the handle. It has a steel pin inside the nylon tip for strength. From Brownells, and absolutely essential.

9. Drift Punch Set

A good set of drift punches will prevent a lot of marred pins. These, from Brownells, are made by Mayhew. The tapered punches at the right are for starting pins, the others for pushing them through. Two sizes are available-4 inches or 6 inches.

10. Roll Pin Punches

These punches by Mayhew are designed specifically for roll pins and have a projection at the center of the tip to fit the hollow center of a roll pin, driving it out without deformation of the ends. From Brownells.

NEXT STEP: Download Your Free Storm Tactical Printable Target Pack

62 Printable MOA Targets with DOT Drills - Rifle Range in YARDS This impressive target pack from our friends at Storm Tactical contains 62 printable targets for rifle and handgun range use. Target grids and bullseye sizes are in MOA. Ideal for long-range shooting! Get Free Targets

Exit mobile version