A closer look at the Rhino’s inner workings.
A closer look at the Rhino’s inner workings.

You will encounter a slight resistance when pushing the cylinder to the left as you have to overcome the spring pressure of the second locking system of the cylinder. This consists of a spring loaded detent pin placed in the frame of the gun on the opposite side of the breech shield, which is wedged into a specific seat in the rotation arm of the cylinder. The arm of the cylinder is wedged in a special joint which allows ample space for opening of the cylinder for quick reloading.

Safety is a big part of this revolver’s design. The gun cannot fire without the cylinder being locked in place because if the small piston placed in the center of the rotation shaft of the cylinder is not perfectly seated into its notch in the breech shield, the cylinder opening lever will be in the low position, blocking rotation of the cylinder and stopping the whole mechanism.

The revolver cannot fire if the cylinder chamber in the six o’clock position is not aligned with the barrel. A pin placed on the trigger interferes with the plug blocking the cylinder and prevents the trigger from being fully pulled if the plug has not gone into its corresponding notch in the cylinder.

The internal hammer makes the Rhino extremely safe from accidental firing caused by falls and shocks. Nevertheless a special safety prevents the accidental release of the hammer when the revolver is cocked in single action. An accidental release of the hammer could happen only if the gun fell from a great height or as a result of abnormal wear of internal parts.

The Rhino’s light-gathering front sight.
The Rhino’s light-gathering front sight.

In this case the hammer cannot hit the firing pin as a solid plug on the left side of the frame would interfere with the interlink lever preventing the gun firing. This safety can only be disconnected by pulling the trigger fully through.

Advanced design means breaking with tradition and this makes the Rhino a real attention getter. When my 6-inch barrel sample gun arrived at Tucker Guns, it created quite a stir among the employees and customers. There were two standard reactions: “What in the Hell is that?” followed by “That’s weird!” Then the comments start to become complimentary: “Nicely machined!” “Points good!” “Has a good trigger pull,” etc. Everyone had to see it and play with it and all came away liking it.

I was the first gun writer to get one of the 6-inch barrel guns. Up to then everyone had gotten the 2-inch barrel snubnose. That’s fine for it’s purpose but I wanted to get all the accuracy and hunting potential out of the .357 Magnum. I am one of a long line of hunters who condemn the use of the .22LR for game shooting because of the high number of wounded animals that escape to die a lingering death after being imperfectly hit with the diminutive .22LR.Like many older hunters, I say the .32-20 is the best small and medium game cartridge, but it’s a bit hard to find today. Cost trumps humanity and sportsmanship for many folks so the .22 gets used and a lot of game dies a lingering death.

However, the .357 Magnum can be considered a larger-bored .32-20 with a little more killing power – not enough for deer but a far more sure and humane killer of small and medium game than the lowly .22LR. No, the .357 won’t spoil a lot of meat or be too powerful, and anyone with enough hunting ethics to want to kill their game cleanly without suffering will feel a lot better about using it than the .22LR.


  1. It doesn’t matter what the price is, if nobody will carry it. It’s not available in California. It’s too new and too strange. The official company literature states that the MSRP as $800-$900.